Anchor bolt 8/30

Cod Articol	96189FIS
Diameter
Lungime
Marca	Fischer
Caracteristici cheie	Functioning - The FAZ II is suitable for pre-positioned and push-through installation; also suitable for stand-off installation under certain conditions. - Prior to installation, place the hexagon nut in the optimal position (the drive-in pin projects by approx. 3 mm out of the hexagon nut). - When applying the torque, the cone bolt is pulled into the expansion clip and expands it against the drill hole wall. - The head embossing offers a simple control of the anchoring. - In the case of series installation, we recommend using the FABS bolt anchor setting tool.
Info	d_o= Nominal diameter of drill bit. Min. t_d= Recommended drilling depth. h_ef= Effective anchorage depth. t_fix= Grip range. s = Width across flats. kN = Load in kN. The allowable load is valid for one single anchor, at cracked concrete (tensile zone) with concrete class C20/25, incl. partial safety factor γ_f= 1,4 and if the S_cr, N and C_cr, N are taken in to account. Final calculations should comply with the complete European Technical Approval (ETA), this approval is also available on request.

Vedeți toate specificațiile

Ambalat la 1

Specificații

Diameter	M8
Lungime	58 mm
Marca	Fischer
Caracteristici cheie	Functioning - The FAZ II is suitable for pre-positioned and push-through installation; also suitable for stand-off installation under certain conditions. - Prior to installation, place the hexagon nut in the optimal position (the drive-in pin projects by approx. 3 mm out of the hexagon nut). - When applying the torque, the cone bolt is pulled into the expansion clip and expands it against the drill hole wall. - The head embossing offers a simple control of the anchoring. - In the case of series installation, we recommend using the FABS bolt anchor setting tool.
Info	d_o= Nominal diameter of drill bit. Min. t_d= Recommended drilling depth. h_ef= Effective anchorage depth. t_fix= Grip range. s = Width across flats. kN = Load in kN. The allowable load is valid for one single anchor, at cracked concrete (tensile zone) with concrete class C20/25, incl. partial safety factor γ_f= 1,4 and if the S_cr, N and C_cr, N are taken in to account. Final calculations should comply with the complete European Technical Approval (ETA), this approval is also available on request.

Descărcați ca PDF Imprimare

Descărcați ca PDF Imprimare