BENNING ben multimeter mm true rms 7-2 1000 v

Benning MM 7-2 True RMS digital multimeter for industry, service, electrical trade and HVAC technology. Digital display. Analogue bargraph display yes. 4 5/6-digit LCD display (60,000 dots). Backlighting of the LC display. Lowest resolution DC voltage 0.01 mV. Max. Voltage measuring range DC 1000 V. Lowest resolution AC voltage 0.01 mV. Max. Voltage measuring range AC 1000 V. Lowest resolution direct current 0.01 µA. Max. Current measuring range DC 10 A. Lowest resolution alternating current 0.01 µA. Max. Current measuring range AC 10 A. Lowest resolution resistance 0.01 Ohm. Max. Resistance measuring range 60 MOhm. Lowest resolution capacitance 0.01 nF. Max. Capacitance measuring range 10000 µF. Lowest resolution frequency 0.001 Hz. Max. Frequency measuring range 1 MHz. Mains level up to 50 kHz, logic level up to 1 MHz. Lowest resolution temperature 0.1 °C. Max. Temperature measuring range 1090 °C. Temperature measurement yes. Temperature measurement -200 °C - +1090 °C. Continuity test/diode test yes. Continuity test (< 100 ? - 420 ?)/ diode test (3.0 V). True RMS measurement method yes True RMS (AC, AC+DC). Ergonomic housing with integrated rubber protective frame for increased grip and shock resistance. Optical and acoustic socket control (µA/mA and A range) with warning in the event of incorrect measuring range selection. AutoV function with automatic AC/DC switching and measuring range selection. LoZ function with low input impedance (> 2 k?) for suppression of capacitive/inductive interspersed voltages. Low-pass filter (HFR, high frequency suppression, 1000 Hz) for measurements on pulsed motor drives. Volt sensor for non-contact and single-pole phase and cable break testing (2 sensitivities) (LCD/buzzer). Fast continuity/diode test (optical/acoustic). Automatic measuring range selection. Automatic switch-off. Automatic low battery indicator. Instantaneous value memory Data HOLD yes. Measured value memory yes. Maximum value memory yes MAX. Minimum value memory yes MIN. Average value memory yes AVG. Relative value measurement yes REL. Peak value memory yes PEAK. Duty cycle measurements yes. Duty cycle (%).4 mA - 20 mA DC current loop (%). Measuring circuit category CAT IV. Max. Voltage measuring circuit category 600 V. Measuring circuit category CAT III. max. voltage measuring circuit category Voltage measuring circuit category 1000 V. Includes silicone test leads with gold-plated 2 mm and 4 mm measuring tip (screw-on), bag, wire temperature sensor, 3 x 1.5 V Micro/AAA/LR03 batteries, 11 A fuse 10218772), 0.4 A fuse (10231514).